Q. A source address is always a

View solution

Q. In gigabit Ethernet three or more stations are connected by

View solution

Q. The term that is used to set standards to enable intercommunication among equipment from a variety of manufacturers is called

View solution

Q. In 10Base5, the maximum length of the coaxial cable is

View solution

Q. IEEE Standard was adopted by the

View solution

Q. Media access control is the sub layer of

View solution

Q. The minimum frame length for 1O-Mbps Ethernet is 64 bytes and the maximum is

View solution

Q. In half duplex mode of MAC sublayer the stations are connected via

View solution

Q. Fast Ethernet can transmit data at the rate of

View solution

Q. In the full duplex mode of gigabit Ethernet, there is no

View solution

Q. In standard Ethernet, data is converted to a digital signal using the

View solution

Q. 10BaseT is used to connect the stations by using

View solution

Q. Three different encoding schemes were used for all the implementations in

View solution

Q. By using fast Ethernet two stations are connected via

View solution

Q. The original Ethernet has gone through

View solution

Q. Acknowledgments of the frames must be implemented at the

View solution

Q. The line encoding scheme that is used in 1000BaseCX is

View solution

Q. The sublayer of data link layer that frames the data received from upper layer is called

View solution

Q. CRC field is used to show the

View solution

Q. The term that is used to raise the bandwidth and separate collision domains are called

View solution