adplus-dvertising
frame-decoration

Question

How many cross points are needed in a single stage switch with 40 inputs and 50 outputs.

a.

40

b.

50

c.

90

d.

2000

Posted under Networking

Answer: (d).2000

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. How many cross points are needed in a single stage switch with 40 inputs and 50 outputs.

Similar Questions

Discover Related MCQs

Q. The ................. of A TSI controls the order of delivering of slot values that are stored in RAM.

Q. In ..................... each packet of a message need not follow the same path From sender to receiver.

Q. Which type of switching uses the entire capacity of a dedicated link?

Q. In ............... circuit switching, delivery of data is delayed because data must be stored and retrieved from RAM.

Q. In ................, each packet of a message need not follow the same path from sender to receiver.

Q. In .................., each packet of a message follows the same path from sender to receiver.

Q. A permanent virtual circuit involves .................

Q. The packets switching concept was first proposed

Q. Which of the following statements is correct for the use of packet switching?

Q. Examples are packet switching using frame relay, and cell switching using ATM technologies. Select the best fit for answer:

Q. Packet Switch Stream (PSS) was introduced in

Q. A T-switch is used to

Q. A WATS arrangement

Q. An example of a medium-speed, switched communications service is

Q. Switching in the Internet is done by using the datagram approach to packet switching at the

Q. The routing processor searching for the routing table is called

Q. A Virtual-Circuit Network (VCN) is normally implemented in the

Q. Which frame completes the entries in the switching tables

Q. Virtual-Circuit Networks and datagram networks are the sub categories of

Q. The actual communication in a circuit-switched network requires