Question
a.
the employment of additional intelligence within the network enabled more sophisticated error control and link control procedures to be applied
b.
by employing wide bandwidth circuits for the trunk networks substantial economies through extensive sharing of capacity could be achieved
c.
the subdivision of information into individually addressed packets in conjunction with alternative routing arrangement enabled the transmission path to be altered in the event of congestion or individual link failure
d.
all of the above
Posted under Networking
Engage with the Community - Add Your Comment
Confused About the Answer? Ask for Details Here.
Know the Explanation? Add it Here.
Q. Which of the following statements is correct for the use of packet switching?
Similar Questions
Discover Related MCQs
Q. Examples are packet switching using frame relay, and cell switching using ATM technologies. Select the best fit for answer:
View solution
Q. Packet Switch Stream (PSS) was introduced in
View solution
Q. A T-switch is used to
View solution
Q. A WATS arrangement
View solution
Q. An example of a medium-speed, switched communications service is
View solution
Q. Switching in the Internet is done by using the datagram approach to packet switching at the
View solution
Q. The routing processor searching for the routing table is called
View solution
Q. A Virtual-Circuit Network (VCN) is normally implemented in the
View solution
Q. Which frame completes the entries in the switching tables
View solution
Q. Virtual-Circuit Networks and datagram networks are the sub categories of
View solution
Q. The actual communication in a circuit-switched network requires
View solution
Q. In a packet-switched network, resources are allocated
View solution
Q. Datagram switching is done at the
View solution
Q. Setup, data transfer and connection teardown are three phases of
View solution
Q. Only one packet for each destination is allowed at each tick; if there is more than one, they wait for the next tick in
View solution
Q. A switch that connects n inputs to m outputs in a grid, using electronic micro switches at each cross point is called
View solution
Q. In Circuit Switching, the resources needs to be reserved during the
View solution
Q. Circuit Switched Networks are used in
View solution
Q. The port that performs the physical and data link functions of the packet switch is called
View solution
Q. The phase where the establishment of the channels takes place is
View solution
Suggested Topics
Are you eager to expand your knowledge beyond Networking? We've curated a selection of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!
