adplus-dvertising
frame-decoration

Question

The message 11001001 is to be transmitted  using the CRC  polynomial  x3 +1 to protect it from errors. The message that should  be transmitted is :

a.

110010011001

b.

11001001

c.

110010011001001

d.

11001001011

Answer: (d).11001001011

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. The message 11001001 is to be transmitted  using the CRC  polynomial  x3 +1 to protect it from errors. The message that should  be transmitted is :

Similar Questions

Discover Related MCQs

Q. What is the bit rate for transmitting uncompressed 800 x 600 pixel colour frames with 8 bits/pixel at 40 frames/second?

Q. In IPV 4, the IP address 200.200.200.200 belongs to

Q. Which layer of OSI reference model is responsible for decomposition of messages and generation of sequence numbers to 'ensure correct re-composition from end to end of the network?'

Q. A client-server system uses a satellite network, With the satellite at a height of 40,000 kms. What is the best-case delay in response to a request (Note that the speed of light in air is 3,00,000 km/second).

Q. The start and stop bits are used in serial communication for

Q. ___________ is a type of transmission  impairment in which the SIgnal looses strength due to The resistance of the transmission medium.

Q. Match the following :

                List - I                                List - II

a. Call control protocol         i. Interface between Base Transceiver Station (BTS) and Base Station Controller (BSC)

b. A-bis                                  ii. Spread spectrum

c. BSMAP                                iii. Connection management

d. CDMA                                 iv. Works between Mobile Switching Centre (MSC) and Base Station Subsystem (BSS)

Code:
a  b  c  d

Q. An analog signal has a bit rate of 6000 bps and a baud rate of 2000 baud. How many data elements are carried by each signal element?

Q. In a classful addressing, first four bits in Class A IP address is

Q. Consider the following S1 and S2 :

S1 : A hard handover is one in which the channel in the source cell is retained and used for a while in parallel with the channel in the target cell.

S2 : A soft handover is one in which the channel in the source cell is retained and only then the channel in the target cell is engaged.

Q. How many distinct stages are there in DES algorithm, which is parameterized by a 56-bit key?

Q. Which of the following algorithms is not a broadcast routing algorithm?

Q. The period of a signal is 10 ms. What is its frequency in Hertz?

Q. For n devices in a network, ____ , number of duplex-mode links are required, for a mesh topology.

Q. How many characters per second (7 bits + 1 parity) can be transmitted over a 3200 bps line if the transfer is asynchronous? (Assuming 1 start bit and 1 stop bit)

Q. Which of the following is not a field in TCP header ?

Q. What is the propagation time if the distance between the two points is 48,900 ? Assume the propagation speed to be 2.4 x 108 meter/second in cable.

Q. _________________ is a bit-oriented protocol for communication over point-to-point and multi-point links . 

Q. Which one of the following is true for asymmetric-key cryptography?

Q. A Trojan horse is