adplus-dvertising
frame-decoration

Question

___________ conversion involves three techniques: line coding, block coding, and scrambling.

a.

Analog-to-digital

b.

Digital-to-analog

c.

Analog-to-analog

d.

Digital-to-digital

Posted under Physical Layer Networking

Answer: (d).Digital-to-digital

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. ___________ conversion involves three techniques: line coding, block coding, and scrambling.

Similar Questions

Discover Related MCQs

Q. ________ is the process of converting digital data to a digital signal.

Q. _______ provides redundancy to ensure synchronization and inherent error detection.

Q. ________ is normally referred to as mB/nB coding; it replaces each m-bit group with an n-bit group.

Q. ________ provides synchronization without increasing the number of bits.

Q. Two common scrambling techniques are ________.

Q. The most common technique to change an analog signal to digital data is called __________.

Q. The first step in PCM is ________.

Q. There are three sampling methods: __________.

Q. ______ finds the value of the signal amplitude for each sample; ____ finds the change from the previous sample.

Q. While there is (are) only _____ way(s) to send parallel data, there is (are) three subclass(es) of serial transmission.

Q. In ______ transmission, we send 1 start bit (0) at the beginning and 1 or more stop bits (1s) at the end of each byte.

Q. In _________ transmission, we send bits one after another without start or stop bits or gaps. It is the responsibility of the receiver to group the bits.

Q. The ________ mode provides synchronization for the entire stream of bits must. In other words, it guarantees that the data arrive at a fixed rate.

Q. A _________ digital signal includes timing information in the data being transmitted.

Q. In decoding a digital signal, the receiver calculates a running average of the received signal power, called the _______.

Q. The ________ rate defines the number of data elements sent in 1s; the ______ rate is the number of signal elements sent in 1s.

Q. The signal rate is sometimes called the ____ rate.

Q. The data rate is sometimes called the ___ rate.

Q. In a _____ scheme, all the signal levels are on one side of the time axis, either above or below.

Q. In ______ schemes, the voltages are on the both sides of the time axis. For example, the voltage level for 0 can be positive and the voltage level for 1 can be negative.