adplus-dvertising
frame-decoration

Question

The Nyquist theorem specifies the minimum sampling rate to be_______.

a.

equal to the lowest frequency of a signal

b.

equal to the highest frequency of a signal

c.

twice the bandwidth of a signal

d.

twice the highest frequency of a signal

Posted under Physical Layer Networking

Answer: (d).twice the highest frequency of a signal

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. The Nyquist theorem specifies the minimum sampling rate to be_______.

Similar Questions

Discover Related MCQs

Q. Which of the following encoding methods does not provide for synchronization?

Q. Which encoding method uses alternating positive and negative values for 1s?

Q. Which quantization level results in a more faithful reproduction of the signal?

Q. Block coding can help in _______ at the receiver.

Q. In _______ transmission, a start bit and a stop bit frame a character byte.

Q. In asynchronous transmission, the gap time between bytes is _______.

Q. ___________ conversion involves three techniques: line coding, block coding, and scrambling.

Q. ________ is the process of converting digital data to a digital signal.

Q. _______ provides redundancy to ensure synchronization and inherent error detection.

Q. ________ is normally referred to as mB/nB coding; it replaces each m-bit group with an n-bit group.

Q. ________ provides synchronization without increasing the number of bits.

Q. Two common scrambling techniques are ________.

Q. The most common technique to change an analog signal to digital data is called __________.

Q. The first step in PCM is ________.

Q. There are three sampling methods: __________.

Q. ______ finds the value of the signal amplitude for each sample; ____ finds the change from the previous sample.

Q. While there is (are) only _____ way(s) to send parallel data, there is (are) three subclass(es) of serial transmission.

Q. In ______ transmission, we send 1 start bit (0) at the beginning and 1 or more stop bits (1s) at the end of each byte.

Q. In _________ transmission, we send bits one after another without start or stop bits or gaps. It is the responsibility of the receiver to group the bits.

Q. The ________ mode provides synchronization for the entire stream of bits must. In other words, it guarantees that the data arrive at a fixed rate.