Q. The ____ layer is responsible for the movement of a signal across a physical line.

View solution

Q. The ______ layer is responsible for the movement of a signal across a physical section.

View solution

Q. The _______ layer corresponds to the physical layer of the OSI model.

View solution

Q. An STS multiplexer is a ______ device.

View solution

Q. An add/drop multiplexer is a ______ device.

View solution

Q. A regenerator is a ________ device.

View solution

Q. In SONET, for each frame, the bytes are transmitted __________.

View solution

Q. In SONET, for each byte, the bits are transmitted ____________.

View solution

Q. Each ________in a SONET frame can carry a digitized voice channel.

View solution

Q. Line overhead consists of ________ bytes.

View solution

Q. The path overhead consists of ______ bytes.

View solution

Q. In ________ APS, there are normally two lines: one working line and one protection line. Both lines are active all the time.

View solution

Q. In ______ APS, there is one working line and one protection line. The data are normally sent on the working line until it fails.

View solution

Q. In ________APS, there is only one protection line for many working lines. When a failure occurs in one of the working lines, the protection line takes control until the failed line is repaired.

View solution

Q. A control character is sent at the beginning as well as at the end of each block in the synchronous-transmission in order to

View solution

Q. Check sum is used for

View solution

Q. When you store and forward messages in B-ISDN, you are using ................. services.

View solution

Q. Which of the following signal is not standard RS-232-C signal?

View solution

Q. While transmitting odd-parity coded symbols, the number of zeros in each symbol is:

View solution

Q. When the receiver sees five consecutive incoming '1' bits followed by a '0' bit it automatically destuffs ................... in bit stuffing.

View solution