adplus-dvertising

Welcome to the Peripheral Devices MCQs Page

Dive deep into the fascinating world of Peripheral Devices with our comprehensive set of Multiple-Choice Questions (MCQs). This page is dedicated to exploring the fundamental concepts and intricacies of Peripheral Devices, a crucial aspect of Computer Hardware. In this section, you will encounter a diverse range of MCQs that cover various aspects of Peripheral Devices, from the basic principles to advanced topics. Each question is thoughtfully crafted to challenge your knowledge and deepen your understanding of this critical subcategory within Computer Hardware.

frame-decoration

Check out the MCQs below to embark on an enriching journey through Peripheral Devices. Test your knowledge, expand your horizons, and solidify your grasp on this vital area of Computer Hardware.

Note: Each MCQ comes with multiple answer choices. Select the most appropriate option and test your understanding of Peripheral Devices. You can click on an option to test your knowledge before viewing the solution for a MCQ. Happy learning!

Peripheral Devices MCQs | Page 5 of 27

Q41.
During the laser printer's conditioning phase a uniform charge of _____ is placed on the photosensitive drum.
Discuss
Answer: (c).-600 volts
Discuss
Answer: (d).the phone line out of the wall is plugged into the phone port on the modem card
Q43.
After you service a laser printer, you notice dirty print. Which of the following would correct the problem.
Discuss
Answer: (c).Run several blank pages
Q44.
What command is used to reset a MODEM ?
Discuss
Answer: (b).ATZ
Q45.
Modems use _____ transmission.
Discuss
Answer: (b).Asynchronous
Q46.
What command is used to hand up a MODEM when using the "AT Answer Command set"?
Discuss
Answer: (d).ATH
Q47.
When you boot a PC and don't hear any beep, this could suggest which of the following?
Discuss
Answer: (d).Bad or disconnected speaker
Q48.
After displaying the directory of a floppy disk, a different floppy is inserted into the drive. The contents of the original floppy continue to display regardless of the director requests on the other floppies placed in the drive. You remove the drive in question and install it into your test system, and it does not exhibit the problem. You should next replace the:
Discuss
Answer: (c).Floppy drive ribbon cable
Q49.
A customer has just installed a new cd-rw. the system was working fine before the installation, but now the cdrom does not work, what should you suggest that the customer do?
Discuss
Answer: (d).check the jumper setting on the cd-rw
Q50.
Which is the most difficult environmentally to dispose of?
Discuss
Answer: (d).CRTs
Page 5 of 27

Suggested Topics

Are you eager to expand your knowledge beyond Computer Hardware? We've curated a selection of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!