Q. Which of the following is not a conditional control transfer instruction?

View solution

Q. The mnemonic used to perform a subtraction of source with an 8-bit data and jumps to specified relative address if subtraction is non-zero is

View solution

Q. The mnemonic, JNB is used to jump to the specified relative address only if

View solution

Q. The type of operand that is not allowed to use in boolean instructions of 8051 is

View solution

Q. In boolean instructions, the flag that is the only allowed destination operand for two operand instructions is

View solution

Q. Which of the following is not one of the SFR addresses of the ports of 8051?

View solution

Q. Each port line of a port can individually source a current of upto

View solution

Q. Each port line of a port can individually sink a current of upto

View solution

Q. The number of TTL inputs that can be sinked by the port 0 when a logic 0 is sent to a port line as an output port is

View solution

Q. The open drain bidirectional (input or output) port with internal pullups is

View solution

Q. The port that can source or sink 4 LS TTL inputs when being used as an output port on each of its line is

View solution

Q. The port that will source a current of 500 micro amperes when being used as input ports is

View solution

Q. If the EA(active low) signal is grounded then the execution

View solution

Q. When the port lines of a port are to be used as input lines then the value that must be written to the port address is

View solution

Q. Port 1 lines are used during programming of

View solution

Q. The configuration in which each LED receives operating current of 8 mA from power supply while the port lines sink the current on each port line is

View solution

Q. If EA(active low) signal =1, then the execution starts from

View solution

Q. The pin that is grounded for interfacing external EPROM is

View solution

Q. The step that is involved in the procedure of memory interfacing with 8051 is

View solution

Q. The device that is used for deriving chip select signals is

View solution