Q. When the numeric extension unit (NEU) begins its execution, then the signal that is active is

View solution

Q. The register that allows the register programmer to select the required processing options is

View solution

Q. Invalid operation is the exception generated due to

View solution

Q. The exception generated for a too big result to fit in the format is

View solution

Q. If the result is infinity, then the exception generated is

View solution

Q. To operate 8087 in maximum mode, the pin MN/MX (active low) is

View solution

Q. If the result is rounded according to the rounding control bits, then the exception generated is

View solution

Q. The instruction that stores a copy of top of the stack into the memory, and pops the top of the stack is

View solution

Q. The instruction that multiplies the content of the stack top by 2n is

View solution

Q. If the opcode bit is D=1, then the source and destination operands are

View solution

Q. Which of the following is not a data transfer instruction?

View solution

Q. The instruction that performs real or integer multiplication of the specified operand with stack top is

View solution

Q. When the instruction, FDIV is performed, the destination is

View solution

Q. When the instruction, FPREM, is performed, the data stored on to the stack top is

View solution

Q. If ‘x’ is the value stored at the top of the stack, then the instruction F2XMI calculates the expression

View solution

Q. The content of the stack is compared with zero to check whether the content is zero, using the instruction

View solution

Q. The instruction that loads log 10 (to the base 2) to stack top is

View solution

Q. The instructions that are used to program the numeric processor or to handle the internal housekeeping functions are

View solution

Q. When the instruction FINIT performs its function, then the TAG status is

View solution

Q. The instruction that enables the interrupt structure and response mechanism is

View solution