Question
a. Downlink control 1. 100 Mbps
b. Radio communication data rate 2. Residency latency (RL)
c. The average duration
of user’s stay in cell 3. Sending data from a BS to MD
d. FDDI bandwidth 4. 2-Mbps
Codes : a b c d
a.
2 1 4 3
b.
3 4 2 1
c.
4 1 2 1
d.
4 3 1 2
Posted under UGC NET computer science question paper Networking
Engage with the Community - Add Your Comment
Confused About the Answer? Ask for Details Here.
Know the Explanation? Add it Here.
Q. Match the following with respect to the Mobile Computing Architecture. a. Downlink control 1. 100 Mbps b. Radio communication data rate...
Similar Questions
Discover Related MCQs
Q. When data and acknowledgement are sent in the same frame, this is called as
View solution
Q. Encryption and Decryption is the responsibility of ___ Layer.
View solution
Q. An analog signal carries 4 bits in each signal unit. If 1000 signal units are sent per second, then baud rate and bit rate of the signal are ________ and ____________
View solution
Q. The VLF and LF bauds use propagation for communication
View solution
Q. Using the RSA public key crypto system, if p = 13, q = 31 and d = 7, then the value of e is
View solution
Q. Which of the following is widely used inside the telephone system for long-haul data traffic?
View solution
Q. Find the false statement:
View solution
Q. The message 11001001 is to be transmitted using the CRC polynomial x3 +1 to protect it from errors. The message that should be transmitted is :
View solution
Q. What is the bit rate for transmitting uncompressed 800 x 600 pixel colour frames with 8 bits/pixel at 40 frames/second?
View solution
Q. In IPV 4, the IP address 200.200.200.200 belongs to
View solution
Q. Which layer of OSI reference model is responsible for decomposition of messages and generation of sequence numbers to 'ensure correct re-composition from end to end of the network?'
View solution
Q. A client-server system uses a satellite network, With the satellite at a height of 40,000 kms. What is the best-case delay in response to a request (Note that the speed of light in air is 3,00,000 km/second).
View solution
Q. The start and stop bits are used in serial communication for
View solution
Q. ___________ is a type of transmission impairment in which the SIgnal looses strength due to The resistance of the transmission medium.
View solution
Q. Match the following :
List - I List - II
a. Call control protocol i. Interface between Base Transceiver Station (BTS) and Base Station Controller (BSC)
b. A-bis ii. Spread spectrum
c. BSMAP iii. Connection management
d. CDMA iv. Works between Mobile Switching Centre (MSC) and Base Station Subsystem (BSS)
Code:
a b c d
View solution
Q. An analog signal has a bit rate of 6000 bps and a baud rate of 2000 baud. How many data elements are carried by each signal element?
View solution
Q. In a classful addressing, first four bits in Class A IP address is
View solution
Q. Consider the following S1 and S2 :
S1 : A hard handover is one in which the channel in the source cell is retained and used for a while in parallel with the channel in the target cell.
S2 : A soft handover is one in which the channel in the source cell is retained and only then the channel in the target cell is engaged.
View solution
Q. How many distinct stages are there in DES algorithm, which is parameterized by a 56-bit key?
View solution
Q. Which of the following algorithms is not a broadcast routing algorithm?
View solution
Suggested Topics
Are you eager to expand your knowledge beyond Networking? We've curated a selection of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!