Question
a.
(1 - b1)Lp1 + (1 - b2)Lp2
b.
[1 - (b1 + b2)L]p1p2
c.
(1 - b1)L (1 - b2)Lp1p2
d.
1 - (b1Lp1 + b2Lp2)
Posted under GATE cse question paper Networking
Engage with the Community - Add Your Comment
Confused About the Answer? Ask for Details Here.
Know the Explanation? Add it Here.
Q. In a communication network, a packet of length L bits takes link L1 with a probability of p1or link L2 with a probability of p2. Link L1 and L2 have bit error probability of b1 and...
Similar Questions
Discover Related MCQs
Q. A company has a class C network address of 204.204.204.0. It wishes to have three subnets, one with 100 hosts and two with 50 hosts each. Which one of the following options represents a feasible set of subnet address/subnet mask pairs?
View solution
Q. Assume that "host1.mydomain.dom" has an IP address of 145.128.16.8. Which of the following options would be most appropriate as a subsequence of steps in performing the reverse lookup of 145.128.16.8? In the following options "NS" is an abbreviation of "nameserver".
View solution
Q. An IP datagram of size 1000 bytes arrives at a router. The router has to forward this packet on a link whose MTU (maximum transmission unit) is 100 bytes. Assume that the size of the IP header is 20 bytes. The number of fragments that the IP datagram will be divided into for transmission is :
View solution
Q. Which of the following statements is TRUE ?
View solution
Q. Two popular routing algorithms are Distance Vector(DV) and Link State (LS) routing. Which of the following are true?
(S1) Count to infinity is a problem only with DV and not LS routing
(S2) In LS, the shortest path algorithm is run only at one node
(S3) In DV, the shortest path algorithm is run only at one node
(S4) DV requires lesser number of network messages than LS
View solution
Q. Host X has IP address 192.168.1.97 and is connected through two routers R1 and R2 to another host Y with IP address 192.168.1.80. Router R1 has IP addresses 192.168.1.135 and 192.168.1.110. R2 has IP addresses 192.168.1.67 and 192.168.1.155. The netmask used in the network is 255.255.255.224.
Given the information above, how many distinct subnets are guaranteed to already exist in the network?
View solution
Q. The transport layer protocols used for real time multimedia, file transfer, DNS and email, respectively are:
View solution
Q. Which of the following transport layer protocols is used to support electronic mail?
View solution
Q. Consider an instance of TCP’s Additive Increase Multiplicative Decrease (AIMD) algorithm where the window size at the start of the slow start phase is 2 MSS and the threshold at the start of the first transmission is 8 MSS. Assume that a timeout occurs during the fifth transmission. Find the congestion window size at the end of the tenth transmission.
View solution
Q. A layer-4 firewall (a device that can look at all protocol headers up to the transport layer) CANNOT
View solution
Q. While opening a TCP connection, the initial sequence number is to be derived using a time-of-day(ToD) clock that keeps running even when the host is down. The low order 32 bits of the counter of the ToD clock is to be used for the initial sequence numbers. The clock counter increments once per millisecond. The maximum packet lifetime is given to be 64s. Which one of the choices given below is closest to the minimum permissible rate at which sequence numbers used for packets of a connection can increase?
View solution
Q. Which of the following system calls results in the sending of SYN packets?
View solution
Q. In the slow start phase of the TCP congestion control algorithm, the size of the congestion window
View solution
Q. Which one of the following uses UDP as the transport protocol?
View solution
Q. Let the size of congestion window of a TCP connection be 32 KB when a timeout occurs. The round trip time of the connection is 100 msec and the maximum segment size used is 2 KB. The time taken (in msec) by the TCP connection to get back to 32 KB congestion window is _________.
View solution
Q. Which one of the following socket API functions converts an unconnected active TCP socket into a passive socket.
View solution
Q. Packets of the same session may be routed through different paths in
View solution
Q. The maximum window size for data transmission using the selective reject protocol with n-bit frame sequence numbers is:
View solution
Q. Which of the following functionalities must be implemented by a transport protocol over and above the network protocol ?
View solution
Q. Which of the following is not true about User Datagram Protocol in transport layer?
View solution
Suggested Topics
Are you eager to expand your knowledge beyond Networking? We've curated a selection of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!