Q. A hard disk with a transfer rate of 10 Mbytes/ second is constantly transferring data to memory using DMA. The processor runs at 600 MHz, and takes 300 and 900 clock cycles to initiate and complete DMA transfer respectively. If the size of the transfer is 20 Kbytes, what is the percentage of processor time consumed for the transfer operation ?

View solution

Q. Using a larger block size in a fixed block size file system leads to :

View solution

Q. Which of the following requires a device driver?

View solution

Q. A graphics card has on board memory of 1 MB. Which of the following modes can the card not support?

View solution

Q. Consider the situation in which the disk read/write head is currently located at track 45 (of tracks 0-255) and moving in the positive direction. Assume that the following track requests have been made in this order: 40, 67, 11, 240, 87. What is the order in which optimized C-SCAN would service these requests and what is the total seek distance?

View solution

Q. Suppose the following disk request sequence (track numbers) for a disk with 100 tracks is given: 45, 20, 90, 10, 50, 60, 80, 25, 70. Assume that the initial position of the R/W head is on track 50. The additional distance that will be traversed by the R/W head when the Shortest Seek Time First (SSTF) algorithm is used compared to the SCAN (Elevator) algorithm (assuming that SCAN algorithm moves towards 100 when it starts execution) is _________ tracks.

View solution

Q. Consider a disk pack with a seek time of 4 milliseconds and rotational speed of 10000 rotations per minute (RPM). It has 600 sectors per track and each sector can store 512 bytes of data. Consider a file stored in the disk. The file contains 2000 sectors. Assume that every sector access necessitates a seek, and the average rotational latency for accessing each sector is half of the time for one complete rotation. The total time (in milliseconds) needed to read the entire file is _________.

View solution

Q. Consider a typical disk that rotates at 15000 rotations per minute (RPM) and has a transfer rate of 50 × 106 bytes/sec. If the average seek time of the disk is twice the average rotational delay and the controller’s transfer time is 10 times the disk transfer time, the average time (in milliseconds) to read or write a 512 byte sector of the disk is _____________.

View solution

Q. Consider a disk queue with requests for I/O to blocks on cylinders 47, 38, 121, 191, 87, 11, 92, 10. The C-LOOK scheduling algorithm is used. The head is initially at cylinder number 63, moving towards larger cylinder numbers on its servicing pass. The cylinders are numbered from 0 to 199. The total head movement (in number of cylinders) incurred while servicing these requests is:

View solution

Q. Which of the following DMA transfer modes and interrupt handling mechanisms will enable the highest I/O band-width?

View solution

Q. Consider three processes (process id 0, 1, 2 respectively) with compute time bursts 2, 4 and 8 time units. All processes arrive at time zero. Consider the longest remaining time first (LRTF) scheduling algorithm. In LRTF ties are broken by giving priority to the process with the lowest process id. The average turn around time is:

View solution

Q. Consider three processes, all arriving at time zero, with total execution time of 10, 20 and 30 units, respectively. Each process spends the first 20% of execution time doing I/O, the next 70% of time doing computation, and the last 10% of time doing I/O again. The operating system uses a shortest remaining compute time first scheduling algorithm and schedules a new process either when the running process gets blocked on I/O or when the running process finishes its compute burst. Assume that all I/O operations can be overlapped as much as possible. For what percentage of time does the CPU remain idle?

View solution

Q. Consider three CPU-intensive processes, which require 10, 20 and 30 time units and arrive at times 0, 2 and 6, respectively. How many context switches are needed if the operating system implements a shortest remaining time first scheduling algorithm? Do not count the context switches at time zero and at the end.

View solution

Q. Which of the following process scheduling algorithm may lead to starvation

View solution

Q. If the quantum time of round robin algorithm is very large, then it is equivalent to:

View solution

Q. A scheduling algorithm assigns priority proportional to the waiting time of a process. Every process starts with priority zero (the lowest priority). The scheduler re-evaluates the process priorities every T time units and decides the next process to schedule. Which one of the following is TRUE if the processes have no I/O operations and all arrive at time zero?

View solution

Q. Consider the 3 processes, P1, P2 and P3 shown in the table.
Process Arrival time Time Units Required
P1 0 5
P2 1 7
P3 3 4
The completion order of the 3 processes under the policies FCFS and RR2 (round robin scheduling with CPU quantum of 2 time units) are

View solution

Q. Consider the following table of arrival time and burst time for three processes P0, P1 and P2.

Process Arrival time Burst Time
P0 : 0 ms 9 ms
P1 : 1 ms 4 ms
P2 : 2 ms 9 ms

The pre-emptive shortest job first scheduling algorithm is used. Scheduling is carried out only at arrival or completion of processes. What is the average waiting time for the three processes?

View solution

Q. Which of the following statements are true?

I. Shortest remaining time first scheduling may cause starvation
II. Preemptive scheduling may cause starvation
III. Round robin is better than FCFS in terms of response time

View solution

Q. Group 1 contains some CPU scheduling algorithms and Group 2 contains some applications. Match entries in Group 1 to entries in Group 2.

Group I Group II
(P) Gang Scheduling (1) Guaranteed Scheduling
(Q) Rate Monotonic Scheduling (2) Real-time Scheduling
(R) Fair Share Scheduling (3) Thread Scheduling

View solution