Q. LIN is enabled in which of the following channels?

View solution

Q. Can one device have more than one USC interfaces?

View solution

Q. Which of the following conditions is more difficult to attain?

View solution

Q. Timer_A is used in

View solution

Q. Is SPI a full duplex technique?

View solution

Q. The concept of SPI is based on

View solution

Q. Writing on the trailing edge of the clock pulse and reading on the leading edge of the clock pulse is done when

View solution

Q. When CPOL=1 then,

View solution

Q. Is CPKH and CPOL the same

View solution

Q. SPI with the USI can be selected by

View solution

Q. SCLK, SDO, and SDI are found___________on F20x3.

View solution

Q. Transmission and reception are made at a time in SPI?

View solution

Q. When the buffer is________ the low power mode is__________

View solution

Q. Falling edge of the SS pin denotes

View solution

Q. The I2C bus uses which of the following lines

View solution

Q. I2C is faster means of data transfer than SPI?

View solution

Q. Each slave has its unique address.

View solution

Q. Pull-up resistors Rp keep the lines at VCC when

View solution

Q. Rising edge on SDA while SCL is high denotes

View solution

Q. Which of the following is an issue while programming I2C using software?

View solution