Q. .w form is used for operations

View solution

Q. Pre increment addressing is available in MSP430?

View solution

Q. Which out of the following is a correct emulated instruction?

View solution

Q. dadd instruction can act as

View solution

Q. Which of the following instructions do not affect the status bits?

View solution

Q. Their are _____ number of addressing modes found for the source and _____ number of modes for the destination part?

View solution

Q. MSP430 describes reti instruction as

View solution

Q. mov.w R3, R4 takes

View solution

Q. Indexed addressing can be used for

View solution

Q. What do you understand form this instruction mov.w X(PC), R6

View solution

Q. Absolute mode uses which of the following operators?

View solution

Q. Indirect register mode is used by

View solution

Q. Indirect mode and the indirect auto increment mode have which common operator in them

View solution

Q. Are the two instructions similar
mov.w @R5+, R6 and mov.w R6,0( R5)
incd.w R5

View solution

Q. mov.w @PC+,R6 is a type of

View solution

Q. Which instruction is used to call functions?

View solution

Q. ret instruction is used for

View solution

Q. According to conventions being followed, R12 to R15 are used for

View solution

Q. We can store the temporary results across a call instruction with the help of which of the following registers

View solution

Q. Can we allocate variables on the stack?

View solution