Q. What does the CH bit of the DS1307 demonstrate?

View solution

Q. Why are relays used for driving the motors?

View solution

Q. Why are ULN2803 normally used between the micro controllers and the relays?

View solution

Q. Why are opto isolators normally used between the micro controllers and the ULN2803?

View solution

Q. Which of the following is a type of a electromagnetic relay?

View solution

Q. Reed switches show connectivity whenever they are in the presence of an electrical field?

View solution

Q. Which of the following is an application of stepper motors?

View solution

Q. What are normal 4 step sequence of a stepper motor if we start to move in clockwise direction with 0110 value?

View solution

Q. What is the meaning of a step angle?

View solution

Q. For a normal 4 step sequence, what are number of teeth required to accomplish a 2 degree step angle?

View solution

Q. Ounch-inch is a unit of a torque.

View solution

Q. Why do we make the connection of the SCLK for communicating serially between two devices?

View solution

Q. What is the function of the CE pin in SPI?

View solution

Q. Which of the following is correct?

View solution

Q. If CPHA= 0 and CPOL=1, then which of the following is true?

View solution

Q. In SPI write, LSB goes first?

View solution

Q. In AVR, which of the following registers are used for SPI?

View solution

Q. How do we set the SPI, to operate in the master mode 1?

View solution

Q. SPI can act as a half duplex transmission?

View solution

Q. Which frequency is not recommended for SPI clock?

View solution