Q. The starting address sent by the device in vectored interrupt is called as

View solution

Q. The code sent by the device in vectored interrupt is _____ long.

View solution

Q. In vectored interrupts, how does the device identify itself to the processor..?

View solution

Q. DMA interface unit eliminates the need to use CPU registers to transfer data from

View solution

Q. The average time required to reach a storage location in memory and obtain its contents is called the

View solution

Q. The process that periodically checks the status of an I/O devices, is known as

View solution

Q. A bus connecting processor and memory, is known as

View solution

Q. 1000 disks having 1,200,000-hour MTTF and disks being used 24 hours a day, and failed disks are being replaced with a new ones, then no that will fail over five years (43,800 hours) is,

View solution

Q. A unit on the bus that initiates bus requests is called

View solution

Q. Request, which is used for indicating a read request for memory, is known as

View solution

Q. Reads/writes requests to I/O devices, are called

View solution

Q. The average time for reading/writing the 512-byte sector for the disk rotating at 10,000 RPM when its time is 6 ms, its transfer rate is 50 MB/sec, and its controller overhead is 0.2 ms

View solution

Q. 1GB of data is referred in bytes as

View solution

Q. A bus which is designed for allowing processors, I/O devices and memory, is called a

View solution

Q. When the disks rotate at 5400 RPM-15,000 RPM, then they have average rotational latency is between

View solution

Q. The 32-bit, 33MHz PCI bus will have peak bandwidth of about

View solution

Q. Spread of data in the multiple disks, is refered to as

View solution

Q. The data transfer rate is given by the formula

View solution

Q. Measuring the continuous service accomplishment and equivalently of the time to failure from a reference point is called

View solution

Q. The higher availability cost is reduced to 1/N, where N is the

View solution