Question
a.
Set the master-slave jumper to slave on the second drive
b.
Use the IDE configuration software to set the new drive as slave
c.
Verify that you define the new drive as D: in the CMOS setup
d.
Verify that you attach the drive to the connector at the end of the ribbon cable
Posted under Computer Hardware
Engage with the Community - Add Your Comment
Confused About the Answer? Ask for Details Here.
Know the Explanation? Add it Here.
Q. To install a second IDE drive into a computer, you must:
Similar Questions
Discover Related MCQs
Q. Why does a successfully mapped network drive disappear every time you boot the computer?
View solution
Q. This computer component keeps all of the computer's operations synchronized:
View solution
Q. For a CPU, the number of millions of CPU cycles per second is quoted as:
View solution
Q. Type of integrated circuit which consists of arithmetic unit, control unit and some main store is called a
View solution
Q. What is used to change or remove device drivers in Windows?
View solution
Q. Which is the first electrical component to “wake up” when a computer is turned on?
View solution
Q. In the Pentium D, what does the D stand for?
View solution
Q. What is the practical limit for modern CPU clock speeds?
View solution
Q. What is the width of the physical address of an Intel Itanium CPU?
View solution
Q. What is used to provide the proper voltage to a CPU?
View solution
Q. Of the following, which is a common voltage for CPUs?
View solution
Q. What cache was historically on the motherboard, but now often comes on the CPU?
View solution
Q. What kind of RAM is cache typically made of?
View solution
Q. Which of the following terms is used to define the first cache that the CPU uses?
View solution
Q. The CPU uses a series of actions to complete a task. What is this series of actions called?
View solution
Q. Because CPU makers can’t make the processors run much quicker, they are instead doing what?
View solution
Q. You have a system that periodically locks up. You have ruled out software, and now suspect that it is hardware. What should you do first that could help you narrow it down to the component at fault?
View solution
Q. Match the device driver HIMEM.SYS to its operation.
View solution
Q. What is the highest binary number that can be referred to on a three position jumper block?
View solution
Q. What specification covers PC hard cards ?
View solution
Suggested Topics
Are you eager to expand your knowledge beyond Computer Hardware? We've curated a selection of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!