adplus-dvertising
frame-decoration

Question

IEEE 802.11 Direct Sequence Spread Spectrum (DSSS) uses the data rate of

a.

1 or 2 Mbps

b.

6 to 54 Mbps

c.

5.5 and 11 Mbps

d.

2 and 54 Mbps

Posted under Networking

Answer: (a).1 or 2 Mbps

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. IEEE 802.11 Direct Sequence Spread Spectrum (DSSS) uses the data rate of

Similar Questions

Discover Related MCQs

Q. The length of a time slot is exactly same as the

Q. In multiple-secondary, process is a little more involved if there is more than one secondary in

Q. ESP stands for

Q. When the destination station has received the frame then it sends an

Q. An adhoc network cannot send data to other

Q. In IEEE 802.11 frames, when the values of, To DS and from DS are 00, its means the frame is not going to a

Q. CCK Stands for

Q. The frame of the Media Access Control (MAC) layer consists of

Q. The contention free end frame is used to allow the contention-based stations to use the

Q. Bluetooth network consists of one primary device and up to

Q. IEEE 802.11 Infrared uses the Infrared light in the range of

Q. If the value of sub field type is 01 in frame control then it contains the information of

Q. The wireless environment is very

Q. In collision during handshaking, sender assumes that the collision in frames, is because it has not received a

Q. Access Code of Bluetooth frame is of

Q. The bandwidth of Bluetooth devices are

Q. When basic service points are connected, the station within reach can communicate without the use of an

Q. IEEE 802.11 Frequency-Hopping Spread Spectrum (FHSS) uses the Band rate of

Q. A Frame in the baseband layer can be of

Q. In IEEE 802.11 frames, when the values of, To DS and from DS are 11, its means the distribution system is