Q. The identifier that is actually used for data transfer is called the

View solution

Q. The network where there is no resource reservation is called

View solution

Q. Time Division Multiplexing inside a switch, is used by

View solution

Q. A switch in a datagram network uses a routing table that is based on the

View solution

Q. The term that refers the switch does not keep information about the connection state, is

View solution

Q. The Asynchronous Transfer Mode (ATM) network is an example of

View solution

Q. The phase where the establishment of the channels takes place is

View solution

Q. The port that performs the physical and data link functions of the packet switch is called

View solution

Q. Circuit Switched Networks are used in

View solution

Q. In Circuit Switching, the resources needs to be reserved during the

View solution

Q. A switch that connects n inputs to m outputs in a grid, using electronic micro switches at each cross point is called

View solution

Q. Only one packet for each destination is allowed at each tick; if there is more than one, they wait for the next tick in

View solution

Q. Setup, data transfer and connection teardown are three phases of

View solution

Q. Datagram switching is done at the

View solution

Q. In a packet-switched network, resources are allocated

View solution

Q. The actual communication in a circuit-switched network requires

View solution

Q. Virtual-Circuit Networks and datagram networks are the sub categories of

View solution

Q. Which frame completes the entries in the switching tables

View solution

Q. A Virtual-Circuit Network (VCN) is normally implemented in the

View solution

Q. The routing processor searching for the routing table is called

View solution