Q. Unipolar, bipolar, and polar encoding are types of _______ encoding.

View solution

Q. _______ encoding has a transition at the middle of each bit.

View solution

Q. _______ encoding has a transition at the beginning of each 0 bit.

View solution

Q. PCM is an example of _______ conversion.

View solution

Q. If the frequency spectrum of a signal has a bandwidth of 500 Hz with the highest frequency at 600 Hz, what should be the sampling rate, according to the Nyquist theorem?

View solution

Q. The Nyquist theorem specifies the minimum sampling rate to be_______.

View solution

Q. Which of the following encoding methods does not provide for synchronization?

View solution

Q. Which encoding method uses alternating positive and negative values for 1s?

View solution

Q. Which quantization level results in a more faithful reproduction of the signal?

View solution

Q. Block coding can help in _______ at the receiver.

View solution

Q. In _______ transmission, a start bit and a stop bit frame a character byte.

View solution

Q. In asynchronous transmission, the gap time between bytes is _______.

View solution

Q. ___________ conversion involves three techniques: line coding, block coding, and scrambling.

View solution

Q. ________ is the process of converting digital data to a digital signal.

View solution

Q. _______ provides redundancy to ensure synchronization and inherent error detection.

View solution

Q. ________ is normally referred to as mB/nB coding; it replaces each m-bit group with an n-bit group.

View solution

Q. ________ provides synchronization without increasing the number of bits.

View solution

Q. Two common scrambling techniques are ________.

View solution

Q. The most common technique to change an analog signal to digital data is called __________.

View solution

Q. The first step in PCM is ________.

View solution