Q. ................ do not base their routing decisions on measurements or estimates of the current traffic and topology.

View solution

Q. The method of network routing where every possible path between transmitting and receiving DTE is used is called ...............

View solution

Q. In Hierarchical routing, the routers are divided into what is called as .................

View solution

Q. The regions in Hierarchical routing are grouped in to .................

View solution

Q. If a router sends every incoming packet out only on those lines that are going approximately in the right direction is known as .................

View solution

Q. In shortest path routing algorithm, the path length is measured based on .................

View solution

Q. Flooding always choose the ....................

View solution

Q. In military applications where large number of routers may be blown to bits at any instant, we use ...................

View solution

Q. In distributed applications, it is sometimes necessary to update all the databases concurrently, we use .......................

View solution

Q. The set of optimal routes from all sources to a given destination from a tree rooted to the destination is known as .................

View solution

Q. Adaptive routing algorithms get their information from .............

View solution

Q. If the route from I to J is computed in advance, off line, and downloaded to the routers when the network is booted is called as ...................

View solution

Q. In Hierarchical routing for N router subnet, the optimal number of levels is ..............

View solution

Q. The router algorithm takes the decision to changes the route when .................

View solution

Q. If route from router I to router J is computed on line based on the current statistics, then it is called as ....................

View solution

Q. If the subnet uses virtual circuits internally, routing decisions are made only when a new virtual circuit is being setup. This is called as.................

View solution

Q. ................. change their routing decisions to reflect changes in the topology.

View solution

Q. If router J is on the optimal path from router I to router K, then the path from J to K along the same route is ..................

View solution

Q. If router J is on the optimal path from router I to router K, then the optimal path from J to K also falls along the same route is known as ....................

View solution

Q. If a datagram router goes down then ..............

View solution