Question
a.
exhibited by all demodulator, when the input signal to noise ratio is low.
b.
the rapid fall on output signal to noise ratio when the input signal to noise ratio fall below a particular value.
c.
the property exhibited by all A.M. suppressed carrier coherent demodulator.
d.
the property exhibited by correlation receiver.
Posted under UGC NET computer science question paper Networking
Engage with the Community - Add Your Comment
Confused About the Answer? Ask for Details Here.
Know the Explanation? Add it Here.
Q. The threshold effect in demodulator is
Similar Questions
Discover Related MCQs
Q. The …………… field is the SNMP PDV reports an error in a response message.
View solution
Q. End-to-End connectivity is provided from Last-to-Last in
View solution
Q. What services does the internet layer provide?
1. Quality of service
2. Routing
3. Addressing
4. Connection oriented delivery
5. Framing bits
View solution
Q. What is the maximum operating rate of a wireless LAN using infrared communication?
View solution
Q. The cost of the network is usually determined by
View solution
Q. A leased special high-speed connection from the local telephone carrier for business users that transmits at 1.544 mbps is known as ……………. carrier.
View solution
Q. CDMA Cell uses …………… carriers of 1.25 MHz.
View solution
Q. If in an error detection and correction code a message M : “You are good students” is stored as M' :
Youare areyou aregood goodare goodstudents studentsgood.
What is the space required to store M' in general? (assume that ‘n’ is the length of M)
View solution
Q. Device on one network can communicate with devices on another network via a
View solution
Q. What is the maximum window size in sliding window protocol used in a computer network?
View solution
Q. Which of the following are Data Link Layer standard?
1. Ethernet
2. HSSI
3. Frame Relay
4. 10 – Base T
5. Token Ring
View solution
Q. In case of Bus/Tree topology signal balancing issue is overcome by
View solution
Q. Match the following :
List-I
(i) Ethernet
(ii) Token Ring
(iii) Cut-through switch
(iv) Spanning tree
List-I
(a) Deterministic
(b) Utilize the full wire speed
(c) Prevent looping
(d) Checking valid address
View solution
Q. The single stage network is also called
View solution
Q. Which technology is sometime referred to as wireless cable?
View solution
Q. Another name of IEEE 802.11a is …………………
View solution
Q. The unlicensed National Information Infrastructure band operates at the …………. frequency.
View solution
Q. In order that a code is ‘t’ error correcting, the minimum Hamming distance should be:
View solution
Q. The throughput of pure ALOHA is given by:
View solution
Q. The Fiber Distributed Data Interface uses:
View solution
Suggested Topics
Are you eager to expand your knowledge beyond Networking? We've curated a selection of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!
