adplus-dvertising
frame-decoration

Question

A channel has a 1-MHz bandwidth. The SNR for this channel is 63. What is the appropriate bit rate?

a.

4 Mbps

b.

6 Mbps

c.

8 Mbps

d.

12 Mbps

Posted under Physical Layer Networking

Answer: (b).6 Mbps

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. A channel has a 1-MHz bandwidth. The SNR for this channel is 63. What is the appropriate bit rate?

Similar Questions

Discover Related MCQs

Q. Calculate the theoretical channel capacity. If SNR(dB) = 36 and the channel bandwidth is 2 MHz.

Q. Calculate the theoretical highest bit rate of a regular telephone line. The signal-to-noise ratio is usually 3162.

Q. We need to send 265 kbps over a noiseless channel with a bandwidth of 20 kHz. How many signal levels do we need?

Q. A file contains 2 million bytes. How long does it take to download this file using a 56-Kbps channel?

Q. A device is sending out data at the rate of 1000 bps. How long does it take to send a file of 100,000 characters?

Q. What is the bit rate for high-definition TV (HDTV)?

Q. A digitized voice channel is made by digitizing a 4-kHz bandwidth analog voice signal. We need to sample the signal at twice the highest frequency (two samples per hertz). We assume that each sample requires 8 bits. What is the required bit rate?

Q. Assume we need to download text documents at the rate of 100 pages per second. What is the required bit rate of the channel?

Q. If a periodic signal is decomposed into five sine waves with frequencies of 100, 300, 500, 700, and 900 Hz, what is its bandwidth?

Q. Consider the below figure. What are the bits transmitted for the Unipolar system?

Q. How many factors data rate limit depends on

Q. According to Fourier analysis, any composite signal is a combination of sine waves with

Q. Signal to Noise Ratio is the ratio of the two

Q. The difference in the delay of the signal may create a difference in

Q. We cannot send the digital signal directly to the channel, when the channel is

Q. One Picoseconds (PS) is equivalent to

Q. SNR (signal to noise ratio) is equals to

Q. SNR stands for

Q. Data to be transmitted must be transformed into

Q. In induced noise, the impairment is created by sources like