Question
a.
Lower Limit
b.
Upper Limit
c.
Specific signal level
d.
Both b and c
Posted under Physical Layer Networking
Engage with the Community - Add Your Comment
Confused About the Answer? Ask for Details Here.
Know the Explanation? Add it Here.
Q. The Nyquist formula gives us any signal level while Shannon capacity gives us the
Similar Questions
Discover Related MCQs
Q. Increasing the levels of a signal may reduce the
View solution
Q. If signal does not change at all, its frequency is
View solution
Q. A period of 100 ms in microseconds would be equals to
View solution
Q. Analog data refers to information that is
View solution
Q. We send a voice signal from a microphone to a recorder, the transmission is
View solution
Q. The unit that is used to express the state of a signal is
View solution
Q. The data rate depends upon
View solution
Q. Bit rate is measured in
View solution
Q. Periodic analog signals can be classified as
View solution
Q. Digital data refers to the information that is
View solution
Q. Conversion of digital signal to analog signal is
View solution
Q. A sine wave is defined by
View solution
Q. A digital signal is a composite analog signal with
View solution
Q. Digital signals are represented in
View solution
Q. In data communications, the non periodic signals
View solution
Q. The term that refers to loss of strength of a signal is called
View solution
Q. The value of the decibel is positive, if signal is
View solution
Q. The completion of one full pattern is called a
View solution
Q. The term that describes the position of the waveform relative to time 0 is
View solution
Q. Bit Rate is the number of bits sent in
View solution
Suggested Topics
Are you eager to expand your knowledge beyond Networking? We've curated a selection of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!
