adplus-dvertising

Discussion Forum

Que. The term ......... describes the position of the waveform relative to time 0.
a. Frequency
b. Phase
c. Phase Shift
d. Time period
Answer:Phase
Confused About the Answer? Ask for Details Here
Know Explanation? Add it Here

Similar Questions:

A digitized voice channel is made by digitizing a 4-kHz bandwidth analog voice signal. We need to sample the signal at twice the highest frequency (two samples per hertz). We assume that each sample requires 8 bits. What is the required bit rate?
Given an AM radio signal with a bandwidth of 10 KHz and the highest-frequency component at 705 KHz, what is the frequency of the carrier signal?
If the frequency spectrum of a signal has a bandwidth of 500 Hz with the highest frequency at 600 Hz, what should be the sampling rate, according to the Nyquist theorem?
Which of the following statements is correct?
A _________ digital signal includes timing information in the data being transmitted.
The Nyquist formula gives us any signal level while Shannon capacity gives us the
What is the bit rate for high-definition TV (HDTV)?
We cannot send the digital signal directly to the channel, when the channel is
Consider the below figure. What are the bits transmitted for the Unipolar system?
The _________ product defines the number of bits that can fill the link.
If communication software can be called the "traffic cop" of a micro communication system, then what should the modem be called?
A smart modem can dial, hang up and answer incoming calls automatically. Can you tell who provides the appropriate instruction to the modem for this purpose?
_________ conversion is the representation of analog information by an analog signal.
________ provides synchronization without increasing the number of bits.
In baseband transmission, the required bit rate is proportional to the
Which of the following is used for modulation and demodulation?
SNR (signal to noise ratio) is equals to
_______ describes the position of the waveform relative to time 0.
In decoding a digital signal, the receiver calculates a running average of the received signal power, called the _______.
There are three sampling methods: __________.

GATE CSE Resources

Questions from Previous year GATE question papers

UGC NET Computer science Resources

UGC NET Previous year questions and practice sets

NET General Paper 1

UGC NET Previous year questions and practice sets

GATE CSE Online Test

Attempt a small test to analyze your preparation level. This GATE exam includes questions from previous year GATE papers.

UGC NET practice Test

Practice test for UGC NET Computer Science Paper. The questions asked in this NET practice paper are from various previous year papers.