adplus-dvertising
frame-decoration

Question

A high paging rate

a.

may cause a high I/O rate

b.

keeps the system running well

c.

is a symptom of too much processor activity

d.

always creates a slow system

Posted under Swapping Operating System

Answer: (a).may cause a high I/O rate

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. A high paging rate

Similar Questions

Discover Related MCQs

Q. Which scheduler performs the "swapping out" or "swapping in"?

Q. Which technique is used to temporarily removing non-active programs from the memory of computer system?

Q. Where does the swap space reside?

Q. Which of the following is / are the essential contents in each entry of a page table?

Q. The term ‘page traffic’ describes

Q. Poor response time is usually caused by

Q. Locality of reference implies that the page reference being made by a process

Q. ____________ is a technique of temporarily removing inactive programs from the memory of computer system

Q. State true of false.

i) With paging, each process is divided into relatively small, fixed-size pages.
ii) Segmentation provides for the use of pieces of varying size.

Q. Moving Process from main memory to disk is called

Q. Address Binding is :

Q. Binding of instructions and data to memory addresses can be done at :

Q. If the process can be moved during its execution from one memory segment to another, then binding must be :

Q. Dynamic loading is :

Q. The advantage of dynamic loading is that :

Q. The idea of overlays is to :

Q. The ___________ must design and program the overlay structure.

Q. The ___________ swaps processes in and out of the memory.

Q. If a higher priority process arrives and wants service, the memory manager can swap out the lower priority process to execute the higher priority process. When the higher priority process finishes, the lower priority process is swapped back in and continues execution. This variant of swapping is sometimes called :

Q. If binding is done at assembly or load time, then the process _____ be moved to different locations after being swapped out and in again.