adplus-dvertising
frame-decoration

Question

Which of the following devices takes data sent from one network device and forwards it to the destination node based on MAC address?

a.

Hub

b.

Switch

c.

Gateway

d.

Modem

Posted under Physical Layer Networking

Answer: (b).Switch

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. Which of the following devices takes data sent from one network device and forwards it to the destination node based on MAC address?

Similar Questions

Discover Related MCQs

Q. which of the following devices is used to connect different network segments and manage the traffic between them?

Q. Unipolar, bipolar, and polar encoding are types of _______ encoding.

Q. _______ encoding has a transition at the middle of each bit.

Q. _______ encoding has a transition at the beginning of each 0 bit.

Q. PCM is an example of _______ conversion.

Q. If the frequency spectrum of a signal has a bandwidth of 500 Hz with the highest frequency at 600 Hz, what should be the sampling rate, according to the Nyquist theorem?

Q. The Nyquist theorem specifies the minimum sampling rate to be_______.

Q. Which of the following encoding methods does not provide for synchronization?

Q. Which encoding method uses alternating positive and negative values for 1s?

Q. Which quantization level results in a more faithful reproduction of the signal?

Q. Block coding can help in _______ at the receiver.

Q. In _______ transmission, a start bit and a stop bit frame a character byte.

Q. In asynchronous transmission, the gap time between bytes is _______.

Q. ___________ conversion involves three techniques: line coding, block coding, and scrambling.

Q. ________ is the process of converting digital data to a digital signal.

Q. _______ provides redundancy to ensure synchronization and inherent error detection.

Q. ________ is normally referred to as mB/nB coding; it replaces each m-bit group with an n-bit group.

Q. ________ provides synchronization without increasing the number of bits.

Q. Two common scrambling techniques are ________.

Q. The most common technique to change an analog signal to digital data is called __________.