adplus-dvertising
frame-decoration

Question

An attempt to access a location not owned by a Program is called

a.

Bus conflict

b.

Address fault

c.

Page fault

d.

Operating system fault

Answer: (b).Address fault

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. An attempt to access a location not owned by a Program is called

Similar Questions

Discover Related MCQs

Q. Cache memory works on the principle of

Q. Memory interleaving technique is used to address the memory modules in order to have

Q. In a multiprogramming system, which of the following is used

Q. Associative memory is some times called as

Q. A more efficient way to organise a Page Table is by means of an associative memory having

Q. If there are four ROM ICs of 8K and two RAM ICs of 4K words, than the address range of Ist RAM is (Assume initial addresses correspond to ROMs)

Q. The idea of cache memory is based

Q. If memory access takes 20 ns with cache and 110 ns with out it, then the ratio ( cache uses a 10 ns memory) is

Q. In a memory-mapped I/O system, which of the following will not be there?

Q. Virtual memory consists of

Q. If the main memory is of 8K bytes and the cache memory is of 2K words. It uses associative mapping. Then each word of cache memory shall be

Q. Memory unit accessed by content is called

Q. The performance of cache memory is frequently measured in terms of a quantity called

Q. The cache memory of 1K words uses direct mapping with a block size of 4 words. How many blocks can the cache accommodate?

Q. A page fault

Q. If a block can be placed at every location in the cache, this cache is said to be

Q. For recording, was the block written, the Opteron keeps

Q. The information when is written in the cache, both to the block in the cache and the block present in the lower-level memory, refers to

Q. Average access time of memory for having memory-hierarchy performance is given as

Q. As segment or a page is normally used for block, page-fault and the address-fault is used for