Q. The four common and useful MSI circuits are

View solution

Q. Decoders often come with an enable signal, so that the device is only activated when the enable E equals to ___________.

View solution

Q. When more than one input can be active, the priority ____________ must be used.

View solution

Q. A _________________ is a circuit, which can remember values for a long time or change values when required.

View solution

Q. A ________________ circuit is not suitable in the synchronous circuit design because of its transparency nature.

View solution

Q. There are________________ basic types of flip-flop based on clock trigger.

View solution

Q. The characteristic equation of any flip-flop describes the __________________ of the next state in terms of the present state and inputs.

View solution

Q. The normal data inputs to a flip-flop (D, S and R, J and K, T) are referred to as ________________ inputs.

View solution

Q. Asynchronous inputs, just like synchronous inputs, can be engineered to be ______________.

View solution

Q. ___________ and Clear should not be 0 at the same time; otherwise, both the outputs will be 1, which is known as invalid state.

View solution

Q. Which table indicates the input conditions of the flip-flops necessary to cause all possible next state transitions of a flip-flop?

View solution

Q. When a circuit is self- correcting?

View solution

Q. A PLA consists of two-level____________ circuits on a single chip.

View solution

Q. In which of the following types of counters, the flip-flops do not change states at exactly the same time?

View solution

Q. The number of states through which the counter goes is also known as ____________.

View solution

Q. It contains an equal resistor or current source segment for each possible value of DAC output.

View solution

Q. The total current can be converted into the corresponding voltage by using a/an _______________.

View solution

Q. The number of resistors required for an N-bit DAC is 2N in the case of _____________.

View solution

Q. The characteristics of a DAC, which are generally specified by the manufacturers

View solution

Q. To start the conversion in successive approximation DAC the programmer sets the MSB to ___________ and all other bits to __________.

View solution