adplus-dvertising
frame-decoration

Question

What is the time taken by one machine cycle if crystal frequency is 20MHz?

a.

1.085 micro seconds

b.

0.60 micro seconds

c.

0.75 micro seconds

d.

1 micro seconds

Answer: (b).0.60 micro seconds

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. What is the time taken by one machine cycle if crystal frequency is 20MHz?

Similar Questions

Discover Related MCQs

Q. Find the number of times the following loop will be executed

MOV R6,#200
BACK:MOV R5,#100
HERE:DJNZ R5, HERE
DJNZ R6,BACK
END

Q. What is the meaning of the instruction MOV A,05H ?

Q. Does the two instructions mean the same?
1) BACK: DEC R0

JZ BACK

2) BACK: DJNZ RO, BACK

Q. To initialise any port as an output port what value is to be given to it?

Q. Which out of the four ports of 8051 needs a pull-up resistor for using it is as an input or an output port?

Q. Which of the ports act as the 16 bit address lines for transferring data through it?

Q. Which of the following registers are not bit addressable?

Q. Which instruction is used to check the status of a single bit?

Q. Which addressing mode is used in pushing or popping any element on or from the stack?

Q. Which operator is the most important while assigning any instruction as register indirect instruction?

Q. What is the advantage of register indirect addressing mode?

Q. Which of the following comes under indexed addressing mode?

Q. Is this a valid statement ?
SETB A

Q. When we add two numbers the destination address must always be.

Q. DAA command adds 6 to the nibble if:

Q. If SUBB A,R4 is executed, then actually what operation is being applied?

Q. A valid division instruction always makes:

Q. In 8 bit signed number operations, OV flag is set to 1 if:

Q. In unsigned number addition, status of which bit is important?

Q. Which instructions have no affect on the flags of PSW?